WARNING: When you install a wheel,
always remove any corrosion, dirt or
foreign materials present on the mounting
surfaces of the wheel or the surface of the
wheel hub, brake drum or brake disc that
contacts the wheel...
Other information:
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the pushpins and clip from the rear of the moulding.
Remove the pushpins at the front edge of the moulding...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair...