Lincoln Nautilus: Exterior Lighting / Exterior Lamps
Switching the Turn Signal Lamps On and Off
Push the lever up or down to
switch the turn signal lamps on.
Set the lever to the middle position to switch the turn signal lamps off.
Note: Tap the lever up or down to make the turn signal lamps flash three times.
Switching the Daytime Running Lamps On and Off - Vehicles With: Configurable Daytime Running Lamps
WARNING: The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions. Make sure you switch the headlamps on, as appropriate, during all low visibility conditions. Failure to do so may result in a crash.
- Using the instrument cluster controls on the steering wheel, select Settings.
- Select Vehicle.
- Select Lighting.
- Switch Daytime Running Lights on or off.
The daytime running lamps turn on when all of the following occur:
- You switch the system on.
- You switch your vehicle on.
- The transmission is not in park (P) for vehicles with automatic transmissions or you release the parking brake for vehicles with manual transmissions.
- The lighting control is in the autolamps position.
- The headlamps are off.
Note: Other lighting control positions do not turn on the daytime running lamps.
Switching the Daytime Running Lamps On and Off - Vehicles With: Daytime Running Lamps (DRL)
WARNING: The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions. Make sure you switch the headlamps on, as appropriate, during all low visibility conditions. Failure to do so may result in a crash.
Daytime running lamps are always on unless you switch on the headlamps or your vehicle is in park (P).
Switching the Front Fog Lamps On and Off (If Equipped)
The front fog lamp button is on the lighting control.
Press the button to switch the
front
fog lamps on or off.
Note: Only switch the front fog lamps on during reduced visibility.
Note: The brightness of the daytime running lamps may decrease when the front fog lamps are switched on.
Note: When the lighting control is in the autolamps position, you cannot switch the fog lamps on unless the headlamps are on.
Switching Welcome Lighting On and Off
Lincoln Embrace: Welcome Lighting
Welcome lighting slowly turns on the exterior lamps when you approach your vehicle with an authenticated device or unlock the doors.
- Using the instrument cluster controls on the steering wheel, select Settings.
- Select Vehicle.
- Select Lighting.
- Switch Welcome Lighting on or off.
Exterior Lamp Indicators
Front Fog Lamp
It illuminates when you switch
the
front fog lamps on.
Turn Signal Lamp
It flashes when you switch the
turn
signal lamps on.
Note: An increase in the rate of flashing warns of a failed turn signal lamp bulb.
Exterior Lamp Audible Warning
Exterior Lamps On
Sounds when you open the driver door and the exterior lamps are on.
Autolamps
What Are Autolamps
WARNING: The system does not
relieve you of your responsibility to drive
with due care and attention. You may need
to override the system if it does not turn
the headlamps on in low visibility
conditions, for example daytime fog...
Automatic High Beam Control
How Does Automatic High Beam Control Work
Automatic high beam control turns the high
beams on if it is dark enough and no other
traffic is present. If it detects an approaching
vehicle’s headlamps or tail lamps, or street
lighting ahead, the system turns the high
beams off...
Other information:
Lincoln Nautilus 2018-2024 Service Manual: Glass, Frames and Mechanisms - System Operation and Component Description. Description and Operation
System Operation System Diagram - Power Windows Driver Side Windows Item Description 1 Master Window Control Switch 2 Driver Door Module (DDM) 3 Driver Door Window Regulator Motor 4 Rear Door Window Control Switch 5 Rear Door Module (RDM) 6 Rear Door Window Regulator Motor 7 LIN 8 LIN Passenger Side Windows ..
Lincoln Nautilus 2018-2024 Service Manual: Supplemental Restraint System (SRS) Depowering. General Procedures
Depower WARNING: Incorrect repair techniques or actions can cause an accidental Supplemental Restraint System (SRS) deployment. Never compromise or depart from these instructions. Failure to precisely follow all instructions could result in serious personal injury from an accidental deployment. WARNING: Before beginning any service procedure in this manual, refe..
Categories
- Manuals Home
- 1st Generation Nautilus Owners Manual
- 1st Generation Nautilus Service Manual
- What Is the Electric Parking Brake. Applying the Electric Parking Brake. Applying the Electric Parking Brake in an Emergency. Manually Releasing the Electric Parking Brake
- Engine Oil Capacity and Specification - 2.0L
- Folding the Exterior Mirrors - Vehicles With: Manual Folding Mirrors. Folding the Exterior Mirrors - Vehicles With: Power Folding Mirrors
- New on site
- Most important about car
Changing a Flat Tire
WARNING: If the tire pressure monitor sensor becomes damaged it may not function.
Note: The use of tire sealant may damage your tire pressure monitoring system and should only be used in roadside emergencies. If you must use a sealant, use the Tire Mobility Kit sealant. Replace the tire pressure monitoring system sensor and valve stem on the wheel by an authorized dealer after use of the sealant.
Note: The tire pressure monitoring system indicator light will illuminate when the spare tire is in use. To restore the full function of the monitoring system, all road wheels equipped with tire pressure monitoring sensors must be mounted on the vehicle.
If you get a flat tire while driving, do not apply the brake hea
