Lincoln Nautilus Manuals

Lincoln Nautilus: Seatbelt Systems / Front Seatbelt Buckle. Removal and Installation

Lincoln Nautilus 2018-2025 Service Manual / Body and Paint / Body and Paint / Seatbelt Systems / Front Seatbelt Buckle. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: Driver seat shown, passenger seat similar.

  1. Remove the front seat.
    Refer to: Front Seat (501-10A Front Seats, Removal and Installation).

  1. Remove the front seatbelt buckle.
    1. Disconnect the electrical connector.
    1. Release the wire harness retainers.
    1. Remove the bolt.
      Torque: 26 lb.ft (35 Nm)

Installation

NOTE: During installation, make sure the seatbelt webbing is not twisted and the seatbelts and buckles are accessible to the occupants.

  1. To install, reverse the removal procedure.
  1. Check the seatbelt system for correct operation.
    Refer to: Seatbelt Systems (501-20 Seatbelt Systems) .

    Front Seatbelt Anchor and Pretensioner. Removal and Installation

    Special Tool(s) / General Equipment 501-403Tool, Pretensioner Quick ConnectTKIT-2012D-FLTKIT-2012D-ROW Removal NOTE: Removal steps in this procedure may contain installation details...

    Front Seatbelt Retractor and Pretensioner. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: RH shown, LH similar. Depower the SRS . Refer to: Supplemental Restraint System (SRS) Depowering (501-20 Supplemental Restraint System) ...

    Other information:

    Lincoln Nautilus 2018-2025 Service Manual: Heated Window Grid Wire Repair. General Procedures


    Materials Name Specification Motorcraft® Ultra-Clear Spray Glass CleanerZC-23 ESR-M14P5-A  Motorcraft® Rear Window Defroster RepairPM-11 WSB-M4J58-B  Motorcraft® Lacquer Touch-Up PaintPMPC-19500-XXXXA, PMPM-19500-XXXXG, PMPP-19500-XXXXA ESR-M2P100-C  Repair NOTE: The antenna and heated window grid line material is not embedded into the glass..

    Lincoln Nautilus 2018-2025 Service Manual: B-Pillar Outer Panel. Removal and Installation


    Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spherical Cutter Hot Air Gun MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM -  Flexible Foam Repair3M™ 08463, LORD Fusor® 121 -  Removal If required, restor..

    Categories

    Traction Control

    How Does Traction Control Work

    If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.

    Switching Traction Control On and Off

    WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co

    read more

    Copyright © 2025 www.linautilus.com