Lincoln Nautilus Manuals

Lincoln Nautilus: Handles, Locks, Latches and Entry Systems / Hood Latch. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. NOTE: Some vehicles are equipped with a grille shutter assembly framework only. These vehicles will not have a grille shutter actuator or a grille shutter linkage.

    Remove the active grille shutter.
    Refer to: Active Grille Shutter (501-02 Front End Body Panels, Removal and Installation).

  1. Remove the hood latch.
    1. Disconnect the hood ajar switch electrical connector.
    1. Detach the hood ajar switch electrical connector locator clip.
    1. Remove the hood latch nuts.
      Torque: 106 lb.in (12 Nm)
    1. Disconnect the hood latch release cable from the hood latch.
    1. Remove the hood ajar switch harness from the routing tab and remove the hood latch.

Installation

  1. To install, reverse the removal procedure.

    Fuel Filler Door Latch. Removal and Installation

    Removal Remove the fuel filler door assembly. Refer to: Fuel Filler Door Assembly (501-03 Body Closures, Removal and Installation). Release the clips and remove the fuel filler door latch...

    Hood Latch Release Cable. Removal and Installation

    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

    Other information:

    Lincoln Nautilus 2018-2025 Service Manual: Engine Noise Identification and Location. General Procedures


    NOTE: This procedure uses multiple tools/methods to help locate the source of engine noise. It may be necessary to repeatedly compare the sound between the tools/methods to help locate the source of the noise. NVH symptoms should be identified using the diagnostic tools and techniques that are available...

    Lincoln Nautilus 2018-2025 Service Manual: Passenger Side Register. Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Release the clips and remove the information display trim panel. Use the General Equipment: Interior Trim Remover Remove the bolts and the information dispaly unit...

    Categories

    Traction Control

    How Does Traction Control Work

    If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces power at the same time. If the wheels spin when accelerating on slippery or loose surfaces, the system reduces power in order to increase traction.

    Switching Traction Control On and Off

    WARNING: The stability and traction control light illuminates steadily if the system detects a failure. Make sure you did not manually disable the traction control system using the information display controls or the switch. If the stability control and traction control light is still illuminating steadily, have the system serviced by an authorized dealer immediately. Operating your vehicle with the traction co

    read more

    Copyright © 2025 www.linautilus.com