Other information:
Check
NOTE:
The object used in this system check can be
fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in
length (available as Polyvinyl Chloride (PVC) pipe, or similar from a
hardware or plumbing supply.
NOTE:
The following system check should be carried out with the vehicle on a level surface...
Removal
NOTE:
RH side is shown, the LH side is similar.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19)
.
Remove the rivets, the pin type retainer and the cellular phone antenna.
Installation
To install, reverse the removal procedure...