Lincoln Nautilus: Wipers and Washers / Washers
Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41°F (5°C),
use washer fluid with antifreeze protection.
Failure to use washer fluid with antifreeze
protection in cold weather could result in
impaired windshield vision and increase
the risk of injury or accident.
Do not operate the washers when the
washer reservoir is empty. This could cause
the washer pump to overheat.
Keep the outside of the windshield clean.
The rain sensor is very sensitive and the
wipers may operate if dirt, mist or insects hit
the windshield.
Using the Windshield Washer
Pull the lever toward you to
operate the windshield washer.
Note: A courtesy wipe occurs a short time
after the wipers stop to clear any remaining
washer fluid when switched on. See
Switching the Courtesy Wipe On and Off.
Switching the Courtesy Wipe On and Off
- Using the instrument cluster controls on
the steering wheel, select Settings.
- Select Vehicle.
- Select Wipers.
- Switch Courtesy Wipe on or off.
Using the Rear Window Washer

Push the lever away from you to operate the
rear window washer.
Note: A courtesy wipe occurs a short time
after the wipers stop to clear any remaining
washer fluid when switched on. See
Switching the Courtesy Wipe On and Off.
Adding Washer Fluid

Washer Fluid Specification
See Washer Fluid Specification.
Lift the wiper arm.Note: Do not hold the wiper blade to lift
the
wiper arm.
Remove the wiper blade.Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached...
Wipers and Washers – Warning Lamps
Illuminates when the windshield
washer fluid is low.
Wipers and Washers – Frequently Asked Questions
Why are there streaks and smears on the
windshield?
The wiper blades could be dirty, worn
or damaged...
Other information:
Removal
NOTE:
This procedure can be used for all locations of the component.
Remove the screw cover.
Remove the screw and position the rear lamp assembly.
Disconnect the electrical connector and remove the rear lamp assembly...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is not necessary to upload
the module configuration information to the diagnostic scan tool prior
to removing the module. If the RDM is replaced with a part with the same
suffix level, the DDM and PDM will automatically transfer the
respective configuration to the new RD..