Other information:
Removal
On both sides.
Release the clips, the pin-type retainer and remove the floor console lower trim panel.
On both sides.
Release the clips and remove the floor console middle trim panel.
Remove the floor console rear trim panel.
On both sides.
Remove the screws.
On both sides.
Release the spring retainer...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Using a diagnostic scan tool, begin the PMI process for the DSP following the on..