Other information:
Removal
Remove the headlamp assembly.
Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
Remove the screws and position the ballast.
Disconnect the electrical connectors and remove the ballast.
Installation
To install, reverse the removal procedure.
..
Oil Pressure Test 2.7L EcoBoost & 3.3L Duratec & 5.0L Ti-VCT
NOTE:
It is necessary to disconnect the battery to avoid
setting any DTCs that could cause the PCM to command the oil pressure to
other than what should be observed from a correctly operating system
during the oil pressure test.
Disconnect the battery ground cable. For additional information, refer to: Battery Disc..