Lincoln Nautilus: Climate Control System - General Information / Blower Motor. Removal and Installation
Removal
-
Remove the passenger knee air bag.
Refer to: Passenger Knee Airbag (501-20B Supplemental Restraint System, Removal and Installation).
-
Disconnect the electrical connector, detach the wiring
harness retainer and position aside the harness. Remove the retainers
and the blower motor.
Installation
-
To install, reverse the removal procedure.
Removal
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
Detach and remove the ambient air temperature sensor...
Removal
Remove the pin-type retainers and the lower RH trim panel.
Remove the hush panel pin-type retainers...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the inboard child safety seat tether anchor bezel.
Release the backrest lower J-clip. Unzip the inboard backrest cover and remove the armrest fasteners...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Insert trim tool in location(s) shown.
Rotate the tool 90 degrees to release the overhead console rear retainers.
Working from the rear to the front along each side release the overhead console retainers...
Categories
What Is Auto-Start-Stop
The system is designed to help reduce fuel
consumption and CO2 emissions by stopping
the engine when it is idling, for example at
traffic lights.
Auto-Start-Stop Precautions
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you leave your
vehicle. Failure to follow this instruction
could result in personal injury or death.
WARNING: Apply the parking brake,
shift into park (P), switch the ignition off
and remove the key before you open the
hood or have any service or repair work
completed. If you do not switch the ignition
off, the engine could restart at any time.
Failure to follow this instruction could result
in personal injury or d
read more