Lincoln Nautilus: Body Closures / Fuel Filler Door. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Open the fuel filler door.
-
Using a screwdriver, pry the retaining tab back and slide the fuel filler door from the fuel filler door hinge.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door...
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Knife
Removal
NOTE:
The fuel filler door assembly is damaged during the removal
process and requires a new fuel filler door assembly installed...
Other information:
What Is the Tire Sealant and Inflator Kit
Tire Inflator and Sealant Kit
The kit consists of an air compressor to
re-inflate the tire and a canister of sealing
compound that will effectively seal most
punctures. This kit will provide a temporary
tire repair allowing you to drive your vehicle
up to 120 mi (200 km) at a maximum speed
of 50 mph (80 km/h) to reach a tire service
location...
DISASSEMBLY
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
On both sides.
Disconnect the electrical connector.
Separate the wire harness retainer.
Remove the screws and the daytime running lamp assembly...