Lincoln Nautilus Manuals

Lincoln Nautilus: Parking Aid - Vehicles With: Rear Parking Aid / Rear Parking Aid Sensor. Removal and Installation

Lincoln Nautilus 2018-2026 Service Manual / Electrical / Instrumentation and Warning Systems / Parking Aid - Vehicles With: Rear Parking Aid / Rear Parking Aid Sensor. Removal and Installation

Removal

NOTE: This procedure can be used for all locations of the component.

  1. Remove the rear bumper cover.
    Refer to: Rear Bumper Cover (501-19) .

  1. Remove the rear parking aid sensor.
    1. Disconnect the rear parking aid sensor electrical connector.
    1. Release the tabs.
    1. Remove the rear parking aid sensor from the bracket.

Installation

  1. To install, reverse the removal procedure.
  1. Carry out the azimuth and elevation system checks.
    Refer to: Azimuth System Check (413-13A Parking Aid - Vehicles With: Rear Parking Aid, General Procedures).
    Refer to: Elevation System Check (413-13A Parking Aid - Vehicles With: Rear Parking Aid, General Procedures).
  1. If any sensor fails the checks, diagnose the sensor fault.
    Refer to: Parking Aid (413-13A) .

    Parking Assist Control Module (PAM). Removal and Installation

    Removal NOTE: If installing a new PAM , it is necessary to upload the module configuration information to the scan tool prior to removing the module...

    Parking Aid - Vehicles With: Parking Aid Camera

    ..

    Other information:

    Lincoln Nautilus 2018-2026 Service Manual: Steering Column. Removal and Installation


    Removal NOTICE: To prevent damage to the clockspring, make sure the front wheels are in the straight-ahead position. NOTICE: Precise tolerances are required when manufacturing a steering column. Never install a repaired, rebuilt, aftermarket, or remanufactured steering column. Always install a new steering column. Failure to follow this direction can result in steering column failure. ..

    Lincoln Nautilus 2018-2026 Service Manual: Brake Master Cylinder. Removal and Installation


    Removal NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water. NOTE: Removal steps in this procedure may contain installation details. NOTICE: Before removing the master cylinder, relieve the vacuum in the brake booster or the ..

    Categories

    Opening and Closing the Hood

    Opening the Hood

    Lincoln Nautilus. Opening and Closing the Hood

    Inside the vehicle, pull the hood release handle located under the left-hand side of the instrument panel.

    read more

    Copyright © 2026 www.linautilus.com