Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
NOTE:
New exhaust manifold gaskets, studs, nuts and/or
bolts must be installed when an exhaust manifold is serviced.
NOTE:
Use a Straightedge that is calibrated by the ..
Removal
NOTE:
This step is only necessary if the TRM is being replaced.
Using a diagnostic scan tool, begin the PMI process for the TRM following the on-screen instructions.
Remove the LH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation)
.
Disconnect the electrical connectors, remove the screws and the TRM .
..