Other information:
Check
NOTE:
This procedure does not apply to CV joints, flex couplers or
double cardan joints that are used in some driveshafts. This check is
for single-cross and roller-style joints found in the driveshafts.
NOTE:
Prior to checking driveline angularity, inspect the U-joints for correct operation...
Check
NOTE:
Perform the following pre-checks to make sure module programming completes without errors.
Start the programming session in Key OFF, Engine OFF and prior to initiating programming, turn to KOEO .
Make sure the vehicle battery is fully charged or is
connected to a battery charger...