Lincoln Nautilus: Keyless Entry / Keyless Entry Limitations. Keyless Entry Settings
Keyless Entry Limitations
Make sure your remote control is within 3 ft
(1 m) from the front door handles and the
tailgate.
The system could not function if:
- The remote control remains stationary
for about a minute.
- The vehicle battery has no charge.
- The remote control battery has no
charge.
- There is interference causing issues with
the remote control frequencies.
- The remote control is too close to metal
objects or electronic devices, for example
keys or a cell phone.
Keyless Entry Settings
Switching Keyless Entry On and Off
- Switch the ignition on using an original
key that has not been created as a
MyKey.
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press Locks.
Reprogramming the Unlocking Function
You can enable two-stage unlocking function
allowing you to unlock only the driver door
when you touch the unlock sensor.
Press and hold both the lock and unlock
buttons on the remote control for four
seconds to disable or enable two-stage
unlocking.
If you program the unlocking function so that
only the driver door unlocks, you can unlock
all of the other doors from inside your vehicle
using the power door lock control. You can
unlock individual doors by pulling the interior
door handles on those doors.
Unlocking the Doors
With the remote control within 3 ft (1 m) of
your vehicle, touch the unlock sensor on the
back of the door handle for a brief period
and then pull on the door handle to unlock,
being careful not to touch the lock sensor at
the same time or pull on the door handle too
quickly...
Other information:
WARNING: Always ride and drive
with your seatback upright and properly
fasten your seatbelt. Fit the lap portion of
the seatbelt snugly and low across the
hips. Position the shoulder portion of the
seatbelt across your chest. Pregnant
women must follow this practice...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the electrical connector and position aside the wiring harness...