Other information:
DISASSEMBLY
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
On both sides.
Disconnect the electrical connector.
Separate the wire harness retainer.
Remove the screws and the daytime running lamp assembly.
On both sides.
Disconnect the electrical co..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin ..