Lincoln Nautilus: Wipers and Washers / Replacing the Rear Wiper Blades
- Lift the wiper arm.
Note: Do not hold the wiper blade to lift
the
wiper arm.
- Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
- To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks
into place.
Replacing the Front Wiper Blades
Lift the wiper arm and then press the
wiper blade locking buttons together.Note: Do not hold the wiper
blade to lift the
wiper arm...
Washer Precautions
WARNING: If you operate your
vehicle in temperatures below 41°F (5°C),
use washer fluid with antifreeze protection.
Failure to use washer fluid with antifreeze
protection in cold weather could result in
impaired windshield vision and increase
the risk of injury or accident...
Other information:
Removal
NOTE:
RH seat shown, LH seat similar.
NOTE:
Removal steps in this procedure may contain installation details.
Position the seat all the way back and up.
Disconnect the electrical connector...
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Using a diagnostic scan tool, begin the PMI process for the GWM following the on-screen instructions...
Categories
Camera.
Radar sensor (if equipped).
If a message regarding a blocked sensor or
camera appears in the information display,
something is obstructing the radar signals or
camera images. The radar sensor is behind
the fascia cover in the center of the lower
grille. With a blocked sensor or camera, the
system may not function, or performance
may reduce. See Pre-Collision Assist –
Information Messages.
read more